DTC B2286 Runnable Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2286 | Serial communication signals and CAN communication signals in the circuit between the main body ECU and ECM are inconsistent. |
|

| 1.CHECK OPERATION OF TACHOMETER |
Run the engine and check if the function of the tachometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Clear the DTCs (Click here).
Check for CAN communication system DTC U0146.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the A55*1 or A24*2 ECM connector.

Disconnect the E8 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-8 (TACH) - A55-15 (TACH)*1 E8-8 (TACH) - A24-15 (TACH)*2 | Always | Below 1 Ω |
| E8-8 (TACH) or A55-15 (TACH) - Body ground*1 E8-8 (TACH) or A24-15 (TACH) - Body ground*2 | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER |
Reconnect the connectors.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| E/G Cond | Engine condition/STOP or RUN | STOP: Engine is stopped RUN: Engine is running | - |
|
| ||||
| OK | ||
| ||