AIRBAG SYSTEM > SRS Warning Light Remains ON |


| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click herefor LHD, Click here for RHD).
| Condition | Proceed To |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK BATTERY |
Measure the voltage of the battery.
|
| ||||
| OK | |
| 3.CHECK CONNECTORS |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Check that the connectors are properly connected to the center airbag sensor assembly and combination meter assembly.
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (SOURCE VOLTAGE OF CENTER AIRBAG SENSOR ASSEMBLY) |
![]() |
Disconnect the connectors from the center airbag sensor assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Operate all components of the electrical system (defogger, wipers, headlight, heater blower, etc.).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E30-21 (IG2) - Body ground | Ignition switch ON | 10 to 14 V |
Turn the ignition switch to the LOCK position.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E30-25 (E1) - Body ground | Always | Below 1 Ω |
| E30-26 (E2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (SOURCE VOLTAGE OF COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the F1 connector from the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-1 (B2) - Body ground | Always | 10 to 14 V |
| F1-2 (B) - Body ground | Ignition switch ON | 10 to 14 V |
| F1-13 (IG+) - Body ground | Ignition switch ON | 10 to 14 V |
Turn the ignition switch to the LOCK position.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-12 (E2) - Body ground | Always | Below 1 Ω |
| F1-24 (ES) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK SRS WARNING LIGHT |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Connect the connector to the combination meter assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position.
Check the SRS warning light condition.
|
| ||||
| OK | ||
| ||