ENTRY AND START SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Push-button start function data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the function seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() |
| Tester Connection | Terminal Description | Condition | Specified Condition |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Engine Switch OFF*
| 56 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Engine Switch OFF*
| 200 Ω or more |
| CANL (14) - CG (4) | LOW-level CAN bus line | Engine Switch OFF*
| 200 Ω or more |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Engine Switch OFF*
| 6 kΩ or more |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Engine Switch OFF*
| 6 kΩ or more |
| INSPECT BATTERY VOLTAGE |