Home › BODY › SLIDING ROOF › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ROOF CONSOLE BOX ASSEMBLY


    B131165E02
  1. Remove the roof console box assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    Q6-1 (CLS) - Q6-3 (GND)
    CLOSE
    Below 100 Ω
    Q6-2 (OPN) - Q6-3 (GND)
    OPEN
    Below 100 Ω
    Q6-4 (DOWN) - Q6-3 (GND)
    DOWN
    Below 100 Ω
    Q6-5 (UP) - Q6-3 (GND)
    UP
    Below 100 Ω
    Q6-1 (CLS) - Q6-3 (GND)
    OPEN
    1 kΩ or higher
    Q6-2 (OPN) - Q6-3 (GND)
    CLOSE
    1 kΩ or higher
    Q6-4 (DOWN) - Q6-3 (GND)
    UP
    1 kΩ or higher
    Q6-5 (UP) - Q6-3 (GND)
    DOWN
    1 kΩ or higher

    If the result is not as specified, replace the roof console box assembly.