Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.
The SLIP indicator light blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator light comes on to warn the driver (Click here).

WIRING DIAGRAM


C109476E02


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here for LHD, or Click here for RHD).

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM
A


2.CHECK SLIP INDICATOR LIGHT
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select "Slip Indicator Lamp" in the Active Test and operate the SLIP indicator light using the intelligent tester.

    ABS / VSC / TRC: 
    Item (Display)
    Vehicle Condition / Test Details
    Diagnostic Note
    Slip Indicator Lamp
    Turn SLIP indicator light ON / OFF
    Observe combination meter

  1. Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using the intelligent tester.

    OK:
    The SLIP indicator light turns on or off in accordance with the intelligent tester.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



OK
REPLACE BRAKE ACTUATOR ASSEMBLY
NG


3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).

    OK:
    The SLIP indicator light turns on or off in accordance with the intelligent tester.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY