ENGINE > INSPECTION |
| 1. INSPECT ENGINE COOLANT |
Inspect the engine coolant (Click here).
| 2. INSPECT ENGINE OIL |
Inspect the engine oil (Click here).
| 3. INSPECT BATTERY |
Inspect the battery (Click here).
| 4. INSPECT SPARK PLUGS |
Inspect the spark plugs .
| 5. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly.
Visually check that there is no dirt, blockage, and/or damage to the air cleaner filter element.
| 6. INSPECT IGNITION TIMING |
Warm up the engine.
![]() |
When using the intelligent tester:
Check the ignition timing.
Connect the intelligent tester to the DLC3.
Enter DATA LIST MODE on the intelligent tester.
![]() |
When not using the intelligent tester:
Check the ignition timing.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
![]() |
Remove the No. 1 engine cover.
Pull out the wire harness as shown in the illustration. Connect the clip of the timing light to the wire harness.
Check the ignition timing at idle.
Disconnect terminals 13 (TC) and 4 (CG) of the DLC3.
Check the ignition timing at idle.
Confirm that the ignition timing moves to the advanced angle side when the engine rpm is increased.
Remove the timing light.
| 7. INSPECT ENGINE IDLE SPEED |
![]() |
Warm up the engine.
When using the intelligent tester:
Check the idle speed.
Connect the intelligent tester to the DLC3.
Enter DATA LIST MODE on the intelligent tester.
| Item | Specified Condition |
| M/T | 650 to 750 rpm |
| A/T | 610 to 710 rpm |
![]() |
When not using the intelligent tester:
Check the idle speed.
Using SST, connect the tachometer tester probe to terminal 9 (TAC) of the DLC3.
Check the idle speed.
| Item | Specified Condition |
| M/T | 650 to 750 rpm |
| A/T | 610 to 710 rpm |
| 8. INSPECT COMPRESSION |
Warm up and stop the engine.
Disconnect the injector connectors.
Remove the ignition coils.
Remove the spark plugs.
![]() |
Check the cylinder compression pressure.
Insert a compression gauge into the spark plug hole.
Fully open the throttle.
While cranking the engine, measure the compression pressure.
If the cylinder compression is low, pour a small amount of engine oil into the cylinder through the spark plug hole and inspect again.
| 9. INSPECT CO/HC |
Start the engine.
Run the engine at 2,500 rpm for approximately 180 seconds.
Insert the CO/HC meter testing probe at least 40 cm (1.3 ft) into the tailpipe during idling.
Immediately check CO/HC concentration at idle and/or 2,500 rpm.
If the CO/HC concentration does not comply with regulations, troubleshoot in the order given below.
Check A/F sensor operation .
Check heated oxygen sensor operation .
See the table below for possible causes, and then inspect and repair.
| CO | HC | Problems | Causes |
| Normal | High | Rough idle |
|
| Low | High | Rough idle (fluctuating HC reading) |
|
| High | High | Rough idle (black smoke from exhaust) |
|