Home › ENGINE ยท 2AZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE VALVE LIFTER


    A062842E01
  1. Remove the valve lifters.

    HINT:
    Arrange the valve lifters in the correct order.



2. REMOVE INTAKE VALVE


    A128225E01
  1. Using SST and wooden blocks, compress and remove the valve retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE EXHAUST VALVE


    A128226E01
  1. Using SST and wooden blocks, compress and remove the valve retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the retainer, valve spring and valve.

    HINT:
    Arrange the removed parts in the correct order.



4. REMOVE VALVE STEM OIL SEAL


    A013356E04
  1. Using needle-nose pliers, remove the oil seals.



5. REMOVE VALVE SPRING SEAT


    A062845E01
  1. Using compressed air and a magnetic finger, remove the valve spring seats by blowing air onto them.



6. REMOVE NO. 1 STRAIGHT SCREW PLUG


    A062841
  1. Using a 14 mm straight hexagon wrench, remove the 2 screw plugs and 2 gaskets.

    NOTICE:
    If water leaks from the straight screw plug or the plug corrodes, replace it.



7. REMOVE STUD BOLT


8. REMOVE RING PIN


9. REMOVE INTAKE VALVE GUIDE BUSH
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on wooden blocks.



    A036632E01
  1. Using SST and a hammer, tap out the guide bush.

    SST
    09201-10000   (09201-01050)
    09950-70010   (09951-07100)



10. REMOVE EXHAUST VALVE GUIDE BUSH
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on wooden blocks.



    A036633E03
  1. Using SST and a hammer, tap out the guide bush.

    SST
    09201-10000   (09201-01050)
    09950-70010   (09951-07100)