CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL INTAKE VALVE GUIDE BUSH |
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
| Bush size | Bush bore diameter |
| Use STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard specified clearance between the guide bush and valve stem.
| 2. INSTALL EXHAUST VALVE GUIDE BUSH |
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
| Bush size | Bush bore diameter |
| Use STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| Use O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Heat the cylinder head to 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap in a new guide bush to the specified protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard specified clearance between the guide bush and valve stem.
| 3. INSTALL RING W/HEAD PIN |
![]() |
Using a plastic-faced hammer, tap in a new ring pin to the specified protrusion height.
| 4. INSTALL STUD BOLT |
Using E5 and E7 "torx" sockets, install the stud bolts.

| 5. INSTALL NO. 1 STRAIGHT SCREW PLUG |
![]() |
Using a 14 mm straight hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.
| 6. INSTALL VALVE SPRING SEAT |
![]() |
Install the valve spring seats to the cylinder head.
| 7. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to a new oil seal.
![]() |
Using SST, push in the oil seal.
| 8. INSTALL INTAKE VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the intake valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
![]() |
Using SST and wooden blocks, compress the spring and install the 2 retainer locks.
![]() |
Using a 5 mm pin punch and plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 9. INSTALL EXHAUST VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the valve, compression spring and spring retainer to the cylinder head.
![]() |
Using SST and wooden blocks, compress the spring and install the 2 retainer locks.
![]() |
Using a 5 mm pin punch and plastic hammer, lightly tap the valve stem tip to ensure a proper fit.
| 10. INSTALL VALVE LIFTER |
![]() |
Assemble the valve lifter and the tip of the valve stem with a light coat of engine oil applied.