ENGINE REAR OIL SEAL > REMOVAL |
| 1. SEPARATE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle) |
| 2. SEPARATE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) |
| 3. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts, rear spacer, drive plate and front spacer.
| 4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) |
![]() |
Put matchmarks on the clutch cover assembly and flywheel sub-assembly.
Loosen the 6 bolts one turn at a time until spring tension is released.
Remove the 6 bolts and pull off the clutch cover assembly.
| 5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle) |
| 6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Using SST, hold the crankshaft.
![]() |
Remove the 8 bolts and flywheel.
| 7. REMOVE ENGINE REAR OIL SEAL |
![]() |
Using a knife, cut through the oil seal lip.
Using a screwdriver with its tip taped, pry out the oil seal.