Home › ENGINE ยท 2AZ-FE › ENGINE MECHANICAL › ENGINE ASSEMBLY

ENGINE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT INTAKE MANIFOLD


    A085564
  1. Using a precision straight edge and feeler gauge, measure the surface contacting the cylinder head for warpage.

    Maximum warpage:
    0.20 mm (0.0079 in.)

    If the warpage is greater than maximum, replace the manifold.



2. INSPECT EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    A124780
  1. Using a precision straight edge and feeler gauge, measure the surface contacting the cylinder head for warpage.

    Maximum warpage:
    0.70 mm (0.0276 in.)

    If the warpage is greater than the maximum, replace the manifold.