STARTER > REASSEMBLY |
| 1. INSTALL PLANETARY GEAR |
![]() |
Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.
Install the 3 planetary gears.
| 2. INSTALL RUBBER SEAL |
![]() |
Install the rubber seal to the repair service starter kit.
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Apply high-temperature grease to the washer and armature shaft.
![]() |
Install the starter armature to the starter commutator end frame.
Install the washer.
Using snap ring pliers, securely install a new snap ring to the armature shaft groove.
![]() |
Using a vernier caliper, measure the length of the snap ring.
| 4. INSTALL STARTER COMMUTATOR END FRAME COVER |
![]() |
Install the starter commutator end frame cover to the starter commutator end frame.
| 5. INSTALL STARTER ARMATURE PLATE |
![]() |
Insert the starter armature plate into the starter yoke.
Align the keyway of the starter armature plate with the key inside the starter yoke, and install the starter armature plate.
| 6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Align the rubber of the end frame with the cutout of the starter yoke.
Install the starter commutator end frame to the starter yoke.
| 7. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the protrusion of the starter yoke with the cutout of the repair service starter kit.
![]() |
Install the starter yoke with the 2 through-bolts.
| 8. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Apply high-temperature grease to the plunger and lever.
![]() |
Pull the pinion gear and push down the lever.
![]() |
Temporarily install the magnet starter switch by hooking the plunger into the upper side of the pinion drive lever.
![]() |
Install the magnet starter switch with the 2 nuts.
![]() |
Connect the lead wire to the magnet starter switch with the nut.