DTC B2782 Power Source Control ECU Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2782 | Steering lock motor drive control circuit is defective. |
|

| 1.INSPECT STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E69-1 (GND) | The specified condition should be checked after performing the following:
|
|
| E69-3 (IGE) - E69-1 (GND) | The specified condition should be checked after performing the following:
|
|
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BODY GROUND) |
![]() |
Disconnect the E69 connector from the steering lock ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU) |
![]() |
Disconnect the E7 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E69-3 (IGE) - E7-19 (SLR+) | Always | Below 1 Ω |
| E69-3 (IGE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||