DTC No.
| DTC Detection Condition
| Trouble Area
|
U0073/94
| When any of the following is detected:
- With the IG1 terminal voltage 10 V or more, after the output of data from the skid control ECU is completed, the sending continues for 5 seconds or more.
- With the IG1 terminal voltage 10 V or more, the condition that bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession. (Sent signals cannot be received.)
- With the IG1 terminal voltage 10 V or more, a delay in receiving data from the yaw rate and acceleration sensor and steering angle sensor continues for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the condition that a delay in receiving data from the yaw rate and acceleration sensor and steering angle sensor occurs once or more within 5 seconds occurs 10 times or more within 60 seconds.
| CAN communication system
|
U0100/65
| When either of the following is detected:
- With the IG1 terminal voltage 10 V or more and the vehicle speed 9 mph (15 km/h) or more, data cannot be sent to the ECM for 2 seconds or more.
- With the IG1 terminal voltage 10 V or more and the vehicle speed 9 mph (15 km/h) or more, data cannot be received from the ECM for 2 seconds or more.
| CAN communication system (Skid control ECU to ECM)
|
U0123/62
| When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the yaw rate sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times or more within 60 seconds.
- The condition that data from the yaw rate sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system (Skid control ECU to yaw rate and acceleration sensor)
|
U0124/95
| When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the acceleration sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times or more within 60 seconds.
- The condition that data from the acceleration sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system (Skid control ECU to yaw rate and acceleration sensor)
|
U0126/63
| When either of the following is detected:
- With the IG1 terminal voltage 10 V or more, data from the steering angle sensor cannot be received for 1 second or more.
- With the IG1 terminal voltage 10 V or more, the following occurs 10 times or more within 60 seconds.
- The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.
| CAN communication system (Skid control ECU to steering angle sensor)
|