Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Driver Side Door Lock Motor Circuit

for Preparation Click here


DESCRIPTION

The driver's door lock motor is built into the driver's door lock assembly.
The main body ECU controls the driver's door lock motor to lock/unlock the driver's door. This ECU applies current from terminal ACT+ to terminal ACT- to operate the motor to lock the door. It reverses the direction of the current flow to operate the motor to unlock the door.

WIRING DIAGRAM


B109771E19


B109771E20


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR LOCK MOTOR)


    B065427E23
  1. Inspect LHD models.

    1. Remove the front door lock assembly LH.

    2. Apply battery voltage and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock



    B065429E22
  1. Inspect RHD models.

    1. Remove the front door lock assembly RH.

    2. Apply battery voltage and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4
      Battery negative (-) → Terminal 1
      Lock
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 4
      Unlock



NG
REPLACE FRONT DOOR LOCK ASSEMBLY
OK


2.CHECK WIRE HARNESS (FRONT DOOR LOCK - MAIN BODY ECU (INSTRUMENT PANEL J/B))


  1. Disconnect the front door lock assembly connector.


    B138032E01

  1. Disconnect the ECU (instrument panel J/B) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    (*1) I7-4 (L) - IK-2
    Always
    Below 1 Ω
    (*1) I7-1 (UL) - IJ-2
    Always
    Below 1 Ω
    (*1) IK-2 - Body ground
    Always
    10 kΩ or higher
    (*1) IJ-2 - Body ground
    Always
    10 kΩ or higher
    (*2) M8-4 (L) - IJ-3
    Always
    Below 1 Ω
    (*2) M8-1 (UL) - IJ-2
    Always
    Below 1 Ω
    (*2) IJ-3 - Body ground
    Always
    10 kΩ or higher
    (*2) IJ-2 - Body ground
    Always
    10 kΩ or higher

    *1: LHD
    *2: RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE