PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE BATTERY |
![]() |
Loosen the bolt and nut, and remove the battery clamp.
Remove the battery and battery tray.
| 3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut from the control shaft lever.
Disconnect the transmission control cable assembly from the control shaft lever.
![]() |
Remove the clip and disconnect the transmission control cable assembly from the No. 1 control cable bracket.
| 4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Disconnect the park/neutral position switch connector.
![]() |
Remove the nut, washer and control shaft lever.
![]() |
Using a screwdriver, pry up the lock plate.
![]() |
Remove the lock nut and the lock plate.
![]() |
Remove the 2 bolts and pull out the park/neutral position switch.