Home › TRANSMISSION ยท U250E AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE BATTERY


    A134906
  1. Loosen the bolt and nut, and remove the battery clamp.

  1. Remove the battery and battery tray.



3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    C135109
  1. Remove the nut from the control shaft lever.

  1. Disconnect the transmission control cable assembly from the control shaft lever.



    C135705
  1. Remove the clip and disconnect the transmission control cable assembly from the No. 1 control cable bracket.

    NOTICE:
    Do not hold the resin guide pipe.



4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C135706
  1. Disconnect the park/neutral position switch connector.



    C135707
  1. Remove the nut, washer and control shaft lever.



    C135708
  1. Using a screwdriver, pry up the lock plate.



    C135709
  1. Remove the lock nut and the lock plate.



    C135710
  1. Remove the 2 bolts and pull out the park/neutral position switch.