SHIFT LOCK SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK SHIFT LOCK OPERATION |
Move the shift lever to P.
Turn the engine switch off.
Check that the shift lever cannot be moved from P to any other position
Turn the engine switch on (IG), depress the brake pedal, and check that the shift lever can be moved from P to any other position.
If the operation cannot be done as specified, inspect the shift lock control unit.
| 2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION |
Turn the engine switch off.
When moving the shift lever with the shift lock release button pressed, check that the shift lever can be moved from P to any other position.
If the operation cannot be done as specified, check the shift lever assembly installation condition.
| 3. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 12 (IG) - 3 (E) | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V | |
| 6 (STP) - 3 (E) | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (E) - Body ground | Always | Below 1 Ω |