SHIFT LEVER > ADJUSTMENT |
| 1. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Remove the nut from the control shaft lever.
Disconnect the transmission control cable assembly from the control shaft lever.
![]() |
Push the control shaft fully downward.
Return the control shaft lever 2 notches to the N position.
![]() |
Move the slider in the directions indicated by the arrows and pull up the lock piece.
![]() |
Connect the transmission control cable assembly to the control shaft lever with the nut.
![]() |
Push in the lock piece.
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position.
If it becomes hard to move the shift lever, readjust the shift lever position.