Home › TRANSMISSION · U250E AUTOMATIC TRANSAXLE › SHIFT LEVER

SHIFT LEVER > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION CONTROL SWITCH


    G028380E11
  1. Measure the resistance according to the value(s) in the table below when the shift lever is moved to each position.

    Standard resistance:
    Shift Position
    Tester Connection
    Specified Condition
    4 and 3
    1 - 2
    Below 1 Ω
    Except 4 and 3
    10 kΩ or higher
    L
    5 - 6
    Below 1 Ω
    Except L
    10 kΩ or higher

    If the resistance value is not as specified, replace the transmission control switch.