TRANSMISSION CONTROL CABLE ASSEMBLY > INSTALLATION |
| 1. INSTALL NO. 2 SHIFT CABLE GROMMET RETAINER |
Pass the control cable from the cabin to the engine compartment.
![]() |
Install the No. 2 shift cable grommet retainer with the 2 bolts.
| 2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to the N position.
![]() |
Install the transmission control cable assembly as shown in the illustration.
![]() |
Connect the control cable to the bracket with a new clip.
![]() |
Install the control cable to the control shaft lever with the nut.
![]() |
Push in the lock piece of the transmission control cable.
| 3. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Install the center airbag sensor assembly with the 3 bolts.
Check that there is no looseness in the installation parts of the center airbag sensor assembly.
Connect the holder (with connectors).
Check that the water-proof sheet is properly set.
| 4. INSTALL AIR CONDITIONING UNIT |
| 5. INSTALL NO. 1 AIR CLEANER INLET |
![]() |
Install the No. 1 air cleaner inlet with the bolt.
| 6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Install the air cleaner case with the 3 bolts.
Connect the vacuum hose and hose clamp.
| 7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Install the air cleaner cap sub-assembly, and connect the 3 bands.
![]() |
Connect the mass air flow meter connector (*1).
Connect the No. 2 ventilation hose (*2).
Connect the hose band (*3).
![]() |
Connect the 3 vacuum hoses.
| 8. INSTALL AIR CLEANER INLET ASSEMBLY |
![]() |
Install the air cleaner inlet with the clamp and 2 bolts.
| 9. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the intake duct seal with the 7 clips.
| 10. INSPECT SHIFT LEVER POSITION |
When shifting from the P to the R position with the ignition switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 11. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Remove the nut and transmission control cable from the control shaft lever.
![]() |
Align the protrusions of the park/neutral position switch.
![]() |
Move the slider in the directions indicated by the arrows and pull up the lock piece.
![]() |
Install the control cable to the control shaft with the nut.
![]() |
Push in the lock piece.
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.