TRANSMISSION CONTROL CABLE ASSEMBLY > REMOVAL |
| 1. REMOVE AIR CONDITIONING UNIT |
| 2. REMOVE CENTER AIRBAG SENSOR ASSEMBLY |
Turn back the carpet.
![]() |
Disconnect the holder (with connectors).
Remove the 3 bolts and center airbag sensor assembly.
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and intake duct seal.
| 4. REMOVE AIR CLEANER INLET ASSEMBLY |
![]() |
Remove the 2 bolts, clamp and air cleaner inlet.
| 5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the 3 vacuum hoses.
![]() |
Disconnect the mass air flow meter connector (*1).
Disconnect the No. 2 ventilation hose (*2).
Disconnect the hose band (*3).
![]() |
Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.
| 6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the vacuum hose and hose clamp.
Remove the 3 bolts and air cleaner case.
| 7. REMOVE NO. 1 AIR CLEANER INLET |
![]() |
Remove the bolt and No. 1 air cleaner inlet.
| 8. DISCONNECT NO. 2 SHIFT CABLE GROMMET RETAINER |
![]() |
Turn back the carpet.
Remove the 2 bolts and disconnect the No. 2 shift cable grommet retainer.
Remove the No. 2 shift cable grommet retainer.
| 9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Disconnect the end of the transmission control cable assembly from the shift lock control unit.
Disconnect the transmission control cable assembly from the transmission floor shift assembly while pushing the 2 claws of the floor shift cable.
![]() |
Remove the nut and transmission control cable from the control shaft lever.
![]() |
Remove the clip and disconnect the transmission control cable assembly from the No. 1 control cable bracket.
Pull out the transmission control cable assembly from the body.