Home › TRANSMISSION ยท U250E AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D003654E01
  1. Using SST and a hammer, install a new oil seal to the oil pump body.

    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with MP grease.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C055817E04
  1. Coat a new O-ring with ATF, and install it to the oil pump body.

    NOTICE:
    1. Install the O-ring carefully not to have a twist or a pinching.
    2. Apply enough ATF to the O-ring prior to installation.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D009206E14
  1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D009206E15
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.



5. INSTALL STATOR SHAFT ASSEMBLY


    D003651E01
  1. Align the bolt holes in the stator shaft assembly with those in the front oil pump and gear body sub-assembly.

  1. Using a torx socket (T30), install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



6. INSTALL CLUTCH DRUM OIL SEAL RING


    D026627E01
  1. Coat 2 new clutch drum oil seal rings with ATF.

  1. Install the 2 clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.