UNDERDRIVE CLUTCH > INSPECTION |
| 1. INSPECT UNDERDRIVE PACK CLEARANCE |
![]() |
Install the underdrive clutch to the transaxle case.
Install a dial indicator as shown in the illustration.
Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| 2. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC |
![]() |
Check if the sliding surfaces of the discs, plates and flange are worn or burnt. If necessary, replace them.
| 3. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the underdrive clutch drum bushing.
| 4. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using vernier calipers, measure the free length of the spring together with the spring seat.