Home › TRANSMISSION ยท U250E AUTOMATIC TRANSAXLE › UNDERDRIVE CLUTCH

UNDERDRIVE CLUTCH > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 UNDERDRIVE CLUTCH FLANGE HOLE SNAP RING


    D003701E01
  1. Using a screwdriver, remove the No. 2 underdrive clutch flange hole snap ring.



2. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC


    C134892E01
  1. Remove the flange, 3 discs, and 3 plates from the underdrive clutch drum.



3. REMOVE UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


    D003703E01
  1. Place SST on the clutch balancer and compress the spring with a press.

    SST
    09350-32014   (09351-32070)

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove. This prevents the spring seat from being deformed.
    2. Do not expand the snap ring excessively.



    C056359E01
  1. Remove the clutch balancer from the underdrive clutch drum.



    C056360E04
  1. Remove the return spring from the underdrive clutch drum.



4. REMOVE UNDERDRIVE CLUTCH PISTON SET


    D003705
  1. Remove the underdrive clutch from the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal ring.

  1. Holding the underdrive clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm 2, 57 psi) to the transaxle case to remove the underdrive clutch piston.



5. REMOVE UNDERDRIVE CLUTCH DRUM O-RING


    D026465E03
  1. Using a screwdriver, remove the O-ring from the underdrive clutch drum.