Home › TRANSMISSION ยท U250E AUTOMATIC TRANSAXLE › UNDERDRIVE PLANETARY GEAR

UNDERDRIVE PLANETARY GEAR > REASSEMBLY

for Preparation Click here



1. INSTALL UNDERDRIVE PLANETARY RING GEAR


    D008112E01
  1. Install a new snap ring to the outer race of the tapered roller bearing.

    HINT:
    If replacing the bearing, also replace the counter driven gear with a new one.



    D008113
  1. Using a piston ring compressor, squeeze the snap ring.



    C134902E01
  1. Using SST and a press, press in the outer race of the angular ball bearing.

    SST
    09950-60020   (09951-00890)
    09950-70010   (09951-07100)

    NOTICE:
    Do not damage the snap ring during installation of the outer race.



    C137499E01
  1. Install the underdrive planetary ring gear to the counter driven gear.



    C134900E01
  1. Using snap ring pliers, install the snap ring.



2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY


    C134903E01
  1. Using a press, press the angular ball bearing inner race (rear side) into the underdrive planetary gear.

    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09726-40010  



    C134904
  1. Install the counter driven gear with planetary ring gear to the underdrive planetary gear.



    C134905E01
  1. Using SST and a press, press in the angular ball bearing inner race (front side).

    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09726-40010  

    NOTICE:
    Press the counter driven gear while rotating it.



    C134906E01
  1. Using a press, press in the parking lock gear.

    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09316-20011  

    NOTICE:
    Press the counter driven gear while rotating it.



3. INSTALL DIFFERENTIAL DRIVE PINION


    D026434E01
  1. Using a press, press in the differential drive pinion.

    SST
    09726-40010  
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)

    NOTICE:
    Press the counter driven gear while rotating it.



4. INSTALL CYLINDRICAL ROLLER BEARING RACE INNER


    C134907E01
  1. Using a press, press in the cylindrical roller bearing race inner.

    SST
    09515-21010  
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)

    NOTICE:
    Press the counter driven gear while rotating it.



5. INSTALL FRONT PLANETARY GEAR NUT


    C134897E01
  1. Clamp the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. Using a socket wrench, install a new lock nut.

    Torque:
    280 N*m{ 2,855 kgf*cm , 207 ft.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).



    C056809
  1. Using a chisel and hammer, stake the lock nut.

    CAUTION:
    Be sure that there are no cracks on the nut.