TORQUE CONVERTER CLUTCH AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Inspect the one-way clutch.
![]() |
Set SST into the inner race of the one-way clutch.
Install SST so that it fits in the notch of the converter hub and outer race of the one-way clutch.
![]() |
Stand the torque converter up and turn the SST.
![]() |
Determine the condition of the torque converter clutch assembly.
If the inspection result of the torque converter clutch assembly satisfies the following conditions, replace the torque converter clutch assembly.
Exchange the ATF in the torque converter clutch.
If the ATF is discolored and/or has a foul odor, completely stir the ATF in the torque converter clutch and drain it.
![]() |
Clean and check the oil cooler and oil pipe line.
If the torque converter clutch is inspected or the ATF is exchanged, clean the oil cooler and oil pipe line.
If the ATF is cloudy, inspect the oil cooler (radiator).
![]() |
Prevent deformation of the torque converter clutch and damage to the oil pump gear.
When there is any damage to the end of the bolt for the torque converter clutch and to the bottom of the bolt hole, replace the bolt and the torque converter clutch.
All of the bolts must be the same length.
Bolts with washers must be used.
| 2. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Set up a dial indicator with a roller instrument and measure the drive plate runout.
Check for damage of the ring gear.