CLUTCH UNIT > INSPECTION |
| 1. INSPECT CLUTCH DISC ASSEMBLY |
![]() |
Using vernier calipers, measure the rivet head depth.
![]() |
Install the clutch disc assembly to the transaxle assembly.
Using a dial indicator with a roller instrument, measure the clutch disc assembly runout.
| 2. INSPECT CLUTCH COVER ASSEMBLY |
![]() |
Using vernier calipers, inspect the diaphragm spring for depth and width of wear.
| 3. INSPECT FLYWHEEL SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the flywheel runout.
| 4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY |
![]() |
Check that the bearing moves smoothly without abnormal resistance by turning the sliding parts of the bearing (contact surfaces with the clutch cover) while applying force in the axial direction.
Inspect the bearing for damage or wear. If necessary, replace the release bearing assembly.
| 5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.