CLUTCH UNIT > REASSEMBLY |
| 1. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
| 2. REMOVE AND INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin on the top.
| 3. INSTALL RELEASE FORK SUPPORT |
![]() |
Install the release fork support to the manual transaxle assembly.
| 4. INSTALL RELEASE BEARING HUB CLIP |
Install the release bearing hub clip to the release bearing assembly.
| 5. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply release hub grease to the contact surfaces between the release fork and release bearing, fork and push rod, and fork and fork support.
Install the release fork to the release bearing assembly.
| 6. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
![]() |
Apply clutch spline grease to the input shaft spline as shown in the illustration.
![]() |
Install the release fork with the release bearing assembly to the manual transaxle assembly.
| 7. INSTALL CLUTCH RELEASE FORK BOOT |
| 8. INSTALL MANUAL TRANSAXLE ASSEMBLY |