FLOOR SHIFT LEVER ASSEMBLY > REMOVAL |
| 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 2. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.
| 3. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.
| 4. REMOVE UPPER CONSOLE PANEL |
![]() |
Open the lid of the upper console panel.
Apply protective tape to the area shown in the illustration.
![]() |
Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the upper console panel as shown in the illustration.
with Seat Heater System:
Disconnect each connector.
| 5. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.
| 6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the 2 clips and disconnect the end of the transmission control cable.
![]() |
Pull out the control cable assembly locks.
![]() |
Turn the adjust nut 180° clockwise. While holding the adjust nut, separate the control cable assembly.
| 7. REMOVE FLOOR SHIFT LEVER ASSEMBLY |
![]() |
Remove the 4 bolts and shift lever assembly.