Home › TRANSMISSION ยท E351 MANUAL TRANSAXLE › INPUT SHAFT

INPUT SHAFT > DISASSEMBLY

for Preparation Click here



1. REMOVE 4TH GEAR


    C070515
  1. Hold the input shaft assembly in a vise using aluminum plates.

  1. Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft.

    HINT:
    Use a shop rag or a piece of cloth to keep the snap ring from flying.



    C092867E02
  1. Using SST and a press, remove the input shaft rear bearing and 4th gear.

    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.



2. REMOVE 4TH GEAR NEEDLE ROLLER BEARING


    C069551
  1. Remove the 4th gear needle roller bearing from the input shaft.



3. REMOVE 2ND SYNCHRONIZER OUTER RING


    D031907
  1. Remove the 2nd synchronizer outer ring (No. 4 synchronizer ring) from the No. 2 transmission clutch hub.



4. REMOVE 4TH GEAR BEARING SPACER


    D031906
  1. Remove the 4th gear bearing spacer from the No. 2 transmission clutch hub.



5. REMOVE 3RD GEAR


    C069615
  1. Using 2 screwdrivers and a hammer, remove the No. 2 clutch hub setting shaft snap ring from the input shaft.

    HINT:
    Use a shop rag or a piece of cloth to keep the snap ring from flying.



    D031908E02
  1. Using SST and a press, remove the No. 2 transmission clutch hub and 3rd gear from the input shaft.

    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.



6. REMOVE 3RD GEAR NEEDLE ROLLER BEARING


    C069617
  1. Remove the 3rd gear needle roller bearing from the input shaft.



7. REMOVE NO. 3 SYNCHRONIZER RING


    C069618
  1. Remove the No. 3 synchronizer ring from the 3rd gear.



8. REMOVE NO. 2 TRANSMISSION HUB SLEEVE


    C069619
  1. Remove the No. 2 transmission hub sleeve, 3 No. 2 synchromesh shifting keys, and 3 No. 2 synchromesh shifting key springs from the No. 2 transmission clutch hub.

    HINT:
    Use a shop rag or a piece of cloth to keep the shifting keys and shifting key springs from flying.



9. REMOVE INPUT SHAFT FRONT BEARING


    C092869E02
  1. Using SST and a press, remove the input shaft front bearing (inner race) from the input shaft.

    SST
    09950-00020  

    NOTICE:
    Do not overtighten the SST.