OUTPUT SHAFT > DISASSEMBLY |
| 1. REMOVE 4TH DRIVEN GEAR |
![]() |
Using SST and a press, remove the output shaft rear bearing (inner race) and 4th driven gear.
| 2. REMOVE OUTPUT GEAR SPACER |
![]() |
Remove the output gear spacer from the output shaft.
| 3. REMOVE 2ND GEAR |
![]() |
Using SST and a press, remove the 3rd driven gear and 2nd gear from the output shaft.
| 4. REMOVE NO. 2 SYNCHRONIZER RING SET |
![]() |
Remove the No. 2 synchronizer ring set from the No. 1 transmission clutch hub.
| 5. REMOVE 2ND GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 2nd gear needle roller bearing from the output shaft.
| 6. REMOVE 2ND GEAR BEARING SPACER |
![]() |
Remove the 2nd gear bearing spacer from the output shaft.
| 7. REMOVE 2ND GEAR BUSHING |
![]() |
Remove the 2nd gear bushing from the output shaft.
| 8. REMOVE 2ND GEAR BUSHING BALL |
![]() |
Using a magnetic finger, remove the 2nd gear bush ball from the output shaft.
| 9. REMOVE 1ST GEAR |
![]() |
Using SST and a press, remove the No. 1 transmission clutch hub and 1st gear from the output shaft.
| 10. REMOVE NO. 1 SYNCHRONIZER RING SET |
![]() |
Remove the No. 1 synchronizer ring set from the 1st gear.
| 11. REMOVE 1ST GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 1st gear needle roller bearing from the output shaft.
| 12. REMOVE OUTPUT SHAFT FRONT BEARING |
![]() |
Using SST and a press, remove the output shaft front bearing (inner race) from the output shaft.
| 13. REMOVE REVERSE GEAR |
![]() |
Remove the No. 1 transmission clutch hub, 3 No. 1 synchromesh shifting keys, and 3 No. 1 synchromesh shifting key springs from the reverse gear.