Home › TRANSMISSION · E351 MANUAL TRANSAXLE › SHIFT AND SELECT LEVER SHAFT

SHIFT AND SELECT LEVER SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL CONTROL SHAFT COVER OIL SEAL


    C092886E02
  1. Using SST and a hammer, install a new control shaft cover oil seal to the control shaft cover.

    SST
    09950-60010   (09951-00280)
    09950-70010   (09951-07100)

    Oil seal installation depth:
    28.0 to 29.0 mm (1.1022 to 1.142 in.)



2. INSTALL SELECT SPRING NO. 1 SEAT SHAFT SNAP RING


    C069540
  1. Using a brass bar and a hammer, install the select spring No. 1 seat shaft snap ring.



3. INSTALL NO. 1 SHIFT LEVER INNER


    C091169E07
  1. Install the No. 1 shift lever inner to the shift interlock plate.



4. INSTALL SHIFT INTERLOCK PLATE COVER


    C091167E06
  1. Install the shift interlock plate cover to the shift interlock plate.



5. INSTALL NO. 1 SELECT SPRING SEAT


    C069538
  1. Install the No. 1 select spring seat, No. 1 select return compression spring, and shift interlock plate to the shift and select lever shaft.



6. INSTALL NO. 2 SHIFT LEVER INNER


    C135406
  1. Install the No. 2 shift lever inner, No. 2 select return compression spring and No. 2 select return spring seat to the shift and select lever shaft.

  1. Hold the shift and select lever in a vise using aluminum plates.

  1. Using a brass bar and a hammer, install the select seat snap ring to the shift and select lever shaft.



    C135405E01
  1. Using a pin punch (φ 5 mm) and a hammer, install the 2 shift inner lever slotted pins to the shift and select lever shaft.

    Clearance A:
    0.7 to 1.7 mm (0.0276 to 0.0669 in.)

    Clearance B:
    -0.4 to 0.5 mm (-0.0157 to 0.0197 in.)



7. INSTALL SELECTING BELLCRANK NO. 2 BUSHING


    C069798
  1. Coat the 2 selecting bellcrank No. 2 bushings with MP grease and install them to the No. 2 selecting bellcrank.



8. INSTALL NO. 2 SELECTING BELLCRANK DUST COVER


    C069531
  1. Coat the No. 2 selecting bellcrank dust cover with MP grease and install it to the No. 2 selecting bellcrank.



9. INSTALL SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY


    C069799
  1. Install the selecting bellcrank support sub-assembly to the No. 2 selecting bellcrank.



    C069532
  1. Install the No. 2 selecting bellcrank plate washer, washer, and nut.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



10. INSTALL NO. 1 SELECTING BELLCRANK DUST COVER


    C069530
  1. Install the No. 1 selecting bellcrank dust cover to the No. 2 selecting bellcrank.



11. INSTALL CONTROL SHIFT LEVER BUSHING


    C069529
  1. Install the control shift lever bushing to the No. 2 selecting bellcrank.