Home › TRANSMISSION ยท E351 MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > DISASSEMBLY

for Preparation Click here



1. REMOVE SPEEDOMETER DRIVE GEAR


    C083559
  1. Remove the speedometer drive gear from the front differential case assembly.



2. REMOVE FRONT DIFFERENTIAL RING GEAR


    C083560E01
  1. Put matchmarks on the front differential ring gear and the front differential case.



    C083561
  1. Remove the 16 bolts.

  1. Using a plastic hammer, remove the front differential case.



3. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


    C092887E01
  1. Using SST and a hammer, unstake the staked part of the front differential case.

    SST
    09930-00010  



    C083564
  1. Using a pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case.



4. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT


    C083565
  1. Remove the No. 1 front differential pinion shaft from the front differential case.



5. REMOVE FRONT DIFFERENTIAL SIDE GEAR


    C083566
  1. Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front differential side gears, and 2 front differential side gear thrust washers from the front differential case.

    HINT:
    Remove the 2 pinion thrust washers and side gear thrust washers while turning the front differential pinion.