Home › TRANSMISSION ยท E351 MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT DIFFERENTIAL SIDE GEAR


    C083566
  1. Coat the rotating surface of the front differential side gear with gear oil.

  1. Install the 2 front differential side gear thrust washers to the 2 front differential side gears.

  1. Install the 2 front differential side gears, 2 front differential pinions, and 2 front differential side gear thrust washers to the front differential case.

    HINT:
    Install the 2 front differential pinions with the front differential washers while turning the front differential pinion.



2. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT


    C083565
  1. Coat the rotating surface of the No. 1 front differential pinion shaft with gear oil.

  1. Install the No. 1 front differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.



3. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


    C083567
  1. Using a pin punch and a hammer, install the front differential pinion shaft straight pin to the front differential case.



    C083568
  1. Using a chisel and hammer, stake the front differential case hole.



4. ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH


    C083562
  1. Hold the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.002 to 0.0079 in.)

  1. If backlash is out of specification, select another front differential side gear thrust washer and adjust backlash.

    Thrust washer:
    Part No.
    Thickness: mm (in.)
    Mark
    41361-28230
    1.00
    (0.0394)
    1
    41361-28240
    1.10
    (0.0433)
    2
    41361-28250
    1.20
    (0.0472)
    3
    41361-28260
    1.30
    (0.0512)
    4



5. INSTALL FRONT DIFFERENTIAL RING GEAR


    C092888E03
  1. Using a heater, heat the front differential ring gear to 90 to 100°C (194.0 to 212.0°F).

  1. Clean the surface that contacts the differential case.



    C070796E01
  1. Aligning the matchmarks, quickly install the front differential ring gear to the front differential case.

    Torque:
    106 N*m{ 1,081 kgf*cm , 78 ft.*lbf }



6. INSTALL SPEEDOMETER DRIVE GEAR


    C070795
  1. Install the speedometer drive gear to the front differential case.