Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Clutch Switch Circuit

for Preparation Click here


DESCRIPTION

Clutch switch circuit inspection is necessary for M/T vehicles.
When the clutch pedal is released, the ECM receives positive (+) battery voltage through the ECU IG No. 2 fuse. While depressing the clutch pedal, the clutch switch sends a signal to terminal D of the ECM. The ECM cancels cruise control drive when terminal D receives the signal.

WIRING DIAGRAM


E113306E07


INSPECTION PROCEDURE

1.INSPECT ECM


    A136781E11
  1. Disconnect the C24 connector from the ECM.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    C24-56 (D) - Body ground
    Clutch pedal depressed
    Below 1 V
    Clutch pedal released
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT CLUTCH SWITCH


    E133093E02
  1. Turn the ignition switch off.

  1. Disconnect the A21 connector from the clutch switch.

  1. Remove the clutch switch. (Click here)

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin free (Clutch pedal depressed)
    10 kΩ or higher
    Switch pin pushed in (Clutch pedal released)
    Below 1 Ω



NG
REPLACE CLUTCH SWITCH
OK


3.CHECK HARNESS AND CONNECTOR


    E135408E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    C24-56 (D) - A21-2
    Always
    Below 1 Ω
    C24-56 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - CLUTCH SWITCH)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - CLUTCH SWITCH)