DTC P0571 Brake Switch "A" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0571 | When voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 sec. or more |
|

| 1.READ VALUE ON INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position, and turn the intelligent tester main switch on.
Check the DATA LIST for proper functioning of the stop light switch.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Stp Light SW M | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
|
| ||||
| NG | |
| 2.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY) |
![]() |
Disconnect the A19 connector from the stop light switch.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-2 - Body ground | Always | 10 to 14 V |
| A19-3 - Body ground | Ignition switch ON | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the stop light switch. (Click here)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| 1 - 2 | Switch pin pushed | 10 kΩ or higher |
| 3 - 4 | Switch pin pushed | Below 1 Ω |
Install the stop light switch.
|
| ||||
| OK | |
| 4.CHECK ECM |
![]() |
Reconnect the stop light switch connector.
Disconnect the A55 connector from the ECM. (2GR-FE (LHD))
Disconnect the A24 connector from the ECM. (2AZ-FE, 2GR-FE (RHD))
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| A55-36 (STP) - Body ground*1
A24-36 (STP) - Body ground*2 | Depressed | 10 to 14 V |
| A55-36 (STP) - Body ground*1
A24-36 (STP) - Body ground*2 | Released | Below 1 V |
| A55-35 (ST1-) - Body ground*1
A24-35 (ST1-) - Body ground*2 | Depressed | Below 1 V |
| A55-35 (ST1-) - Body ground*1
A24-35 (ST1-) - Body ground*2 | Released | 10 to 14 V |
|
| ||||
| OK | ||
| ||