CAN COMMUNICATION SYSTEM (for LHD) > Navigation ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Navigation ECU Communication Stop Mode |
|
|

| 1.CHECK OPEN IN CAN BUS WIRE (NAVIGATION ECU BRANCH LINE) |
Turn the ignition switch off.
![]() |
Disconnect the navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F26-2 (CANH) - F26-3 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F27-7 (GND) - Body ground | Always | Below 1 Ω |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F27-3 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| F25-2 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||