Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use this procedure to troubleshoot the wireless door lock control system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check for normal function of the can communication system.
      Result 
      Result
      Proceed To
      CAN DTC is not output
      A
      CAN DTC is output
      for LHD: (Click here)
      for RHD: (Click here)


    A


    4.DTC CHECK
    1. Check for a DTC and note any codes that are output.

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      Result 
      Result
      Proceed To
      DTC does not reoccur
      A
      DTC reoccurs
      Click here


    A


    5.SYMPTOM SIMULATION

      NEXT


      6.PROBLEM SYMPTOMS TABLE
      1. If the fault is not listed in the problem symptoms table, proceed to A.

      2. If the fault is listed in the problem symptoms table, proceed to B.



      B.
      Go to step 8
      A


      7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)

      2. DATA LIST/ACTIVE TEST (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END