Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Entry and Start System)

THEFT DETERRENT SYSTEM (w/o Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. The intelligent tester should be used in step 3.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check for normal function of the can communication system.
      Result 
      Result
      Proceed To
      CAN DTC is not output
      A
      CAN DTC is output
      for LHD: (Click here)
      for RHD: (Click here)


    A


    4.SYMPTOM SIMULATION

      NEXT


      5.PROBLEM SYMPTOMS TABLE
      1. If the fault is not listed in the problem symptoms table, proceed to A.

      2. If the fault is listed in the problem symptoms table, proceed to B.



      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)



      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END