Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM (w/o Entry and Start System)

THEFT DETERRENT SYSTEM (w/o Entry and Start System) > ECU Power Source Circuit


DESCRIPTION

This circuit provides power for main body ECU operation.

WIRING DIAGRAM


B139475E01


INSPECTION PROCEDURE

1.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU) (POWER SOURCE)


    B110545E02
  1. Disconnect the ID J/B connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    ID-10 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - BODY GROUND)


    B110543E02
  1. Disconnect the IF and IM J/B connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    IF-10 - Body ground
    Below 1 Ω
    IM-9 - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE