POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch |

| 1.READ VALUE USING INTELLIGENT TESTER (Main Body) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication P-Door Motor | Connection status between power window regulator motor (for front passenger side) and main body ECU (instrument panel J/B) / OK or STOP | OK: Normal communication STOP: Communication stopped | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (P-Door Motor) |
Enter the following menus: Body / P-Door Motor / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Door P/W Up SW | Front passenger side power window manual up switch signal / ON or OFF | ON: Front passenger door power window manual up switch operated OFF: Front passenger power window manual up switch not operated | - |
| P Door P/W Down SW | Front passenger side power window manual down switch signal / ON or OFF | ON: Front passenger door power window manual down switch operated OFF: Front passenger power window manual down switch not operated | - |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (P-Door Motor) |
Enter the following menus: Body / P-Door Motor / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Power Window | Power window | OFF / UP / DOWN | - |
|
| ||||
| OK | ||
| ||
| 4.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Front Passenger Side) |
![]() |
Remove the power window regulator switch assembly (for front passenger side) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (UP) - 1 (GND) | Auto up or up position | Below 1 Ω |
| 7 (DOWN) - 1 (GND) | Auto down or down position | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (FRONT PASSENGER SIDE SWITCH - MOTOR AND BODY GROUND) |
![]() |
Disconnect the power window regulator motor assembly (for front passenger side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H13-6 (UP) - H12-10 (UP) | Always | Below 1 Ω |
| H13-7 (DOWN) - H12-7 (DOWN) | Always | Below 1 Ω |
| H13-1 (GND) - Body ground | Always | Below 1 Ω |
| H13-6 (UP) - Body ground | Always | 10 kΩ or higher |
| H13-7 (DOWN) - Body ground | Always | 10 kΩ or higher |
| H12-10 (UP) - Body ground | Always | 10 kΩ or higher |
| H12-7 (DOWN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||