Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING
  1. Install the front shock absorber with coil spring to the front axle assembly and insert the 2 bolts from the front side of the vehicle.



    C132410E01
  1. Slowly jack up the vehicle using a wooden block and install the front shock absorber with coil spring (upper side) to the vehicle.



    C132415
  1. Install the 3 nuts to the upper side of the front shock absorber with coil spring.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }



    C132414
  1. Install the 2 nuts to the lower side of the front shock absorber with coil spring.

    Torque:
    210 N*m{ 2,140 kgf*cm , 155 ft.*lbf }

    NOTICE:
    When installing the nuts, keep the bolts from rotating.



    C132413
  1. Install the front flexible hose and front speed sensor wire harness with the bolt.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Do not twist the front speed sensor wire harness when installing it.



    C132412
  1. Fully tighten the lock nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }



2. INSTALL FRONT STABILIZER LINK ASSEMBLY


    C132411
  1. Install the front stabilizer link assembly with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)