FRONT LOWER BALL JOINT > INSTALLATION |
| 1. INSTALL FRONT LOWER BALL JOINT |
Install the front lower ball joint to the steering knuckle with the nut.
Install a new cotter pin.
| 2. INSTALL FRONT AXLE HUB BEARING |
![]() |
Using SST and a press, install a new front axle hub bearing to the steering knuckle.
| 3. INSTALL FRONT DISC BRAKE DUST COVER |
Install the disc brake dust cover to the steering knuckle with the 4 bolts.
| 4. INSTALL FRONT AXLE HUB |
![]() |
Using SST and a press, install the front axle hub sub-assembly.
| 5. INSTALL FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, install a new front axle hub hole snap ring.
| 6. INSTALL FRONT WHEEL NO. 1 BEARING DUST DEFLECTOR |
![]() |
Using SST and a hammer, install a new No. 1 front wheel bearing dust deflector.
| 7. INSTALL FRONT AXLE ASSEMBLY |
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
![]() |
Install the steering knuckle with the front axle assembly to the front shock absorber with the 2 bolts and 2 nuts.
| 8. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM |
![]() |
Install the lower ball joint to the front suspension lower No. 1 arm with the bolt and 2 nuts.
| 9. CONNECT TIE ROD END SUB-ASSEMBLY |
Install the tie rod end sub-assembly to the steering knuckle with the nut.
Install a new cotter pin.
| 10. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the front disc.
| 11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.
| 12. INSTALL FRONT AXLE HUB NUT |
Using a socket wrench (30 mm), install a new axle hub nut.
| 13. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.
| 14. REMOVE FRONT DISC |
![]() |
Remove the front disc.
| 15. INSPECT FRONT AXLE HUB BEARING LOOSENESS |
![]() |
Using a dial indicator, check for looseness near the center of the axle hub.
| 16. INSPECT FRONT AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
| 17. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the front disc.
| 18. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
Install the front disc brake caliper assembly with the 2 bolts to the steering knuckle.
| 19. INSTALL FRONT SPEED SENSOR |
![]() |
Install the front speed sensor to the steering knuckle with the bolt.
![]() |
Install the flexible hose and the speed sensor to the shock absorber with the bolt and set the sensor clip on the knuckle.
| 20. INSTALL FRONT AXLE HUB NUT |
![]() |
Using a chisel and hammer, stake the axle hub nut.
| 21. CHECK ABS SPEED SENSOR SIGNAL |
| 22. INSTALL FRONT WHEEL |
| 23. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |