FRONT LOWER BALL JOINT > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle hub nut.
While applying the brakes, remove the front axle hub nut.
| 3. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and clip, and separate the speed sensor wire and flexible hose from the shock absorber.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.
| 5. REMOVE FRONT DISC |
![]() |
Remove the front disc.
| 6. SEPARATE TIE ROD END SUB-ASSEMBLY |
![]() |
Remove the cotter pin and nut.
Using SST, separate the tie rod end sub-assembly from the steering knuckle.
| 7. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM |
![]() |
Remove the bolt and 2 nuts, and separate the front suspension lower No. 1 arm from the lower ball joint.
| 8. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
![]() |
Remove the 2 bolts, 2 nuts, and front axle assembly.
| 9. REMOVE FRONT WHEEL NO. 1 BEARING DUST DEFLECTOR |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the No. 1 front wheel bearing dust deflector.
| 10. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the front axle hub hole snap ring.
| 11. REMOVE FRONT AXLE HUB |
![]() |
Hold the front axle assembly between aluminium plates in a vise.
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly.
| 12. REMOVE FRONT DISC BRAKE DUST COVER |
Remove the 4 bolts and disc brake dust cover from the steering knuckle.
| 13. REMOVE FRONT AXLE HUB BEARING |
![]() |
Place the bearing inner race (outside) on the front axle hub bearing.
Using SST and a press, press the front axle hub bearing until it contacts the SST.
![]() |
Using SST to make the steering knuckle horizontal, fix it to the V-block as shown in the illustration.
Using SST and a press, remove the front axle hub bearing from the steering knuckle.
| 14. REMOVE FRONT LOWER BALL JOINT |
Secure the steering knuckle in a vise using aluminum plates.
Remove the cotter pin and nut.
![]() |
Using SST, remove the front lower ball joint.