Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING


    C143997E01
  1. Install the 2 front stabilizer bar bushings No. 1 to the outside of the bushing stopper on the front stabilizer bar.

    NOTICE:
    Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.



2. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
  1. Install the front No. 1 stabilizer bracket LH.



3. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
  1. Install the front No. 1 stabilizer bracket RH.



4. INSTALL FRONT STABILIZER BAR


    C143302E01
  1. Install the front stabilizer bar with the 2 bolts. (LH Side)

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }



    C143303E01
  1. Install the front stabilizer bar with the 2 bolts. (RH Side)

    Torque:
    16 N*m{ 163 kgf*cm , 12 ft.*lbf }



5. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for installation of the engine assembly