Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE FRONT WHEELS


4. SEPARATE STEERING SLIDING YOKE


    C133501
  1. Secure the steering wheel with the seat belt in order to prevent rotation.

    HINT:
    This operation is useful to prevent damage to the spiral cable.



    C132548E02
  1. Remove the bolt and slide the steering sliding yoke.

    NOTICE:
    Do not separate the steering sliding yoke from the power steering link assembly.



    C132549E01
  1. Put matchmarks on the steering sliding yoke and the power steering link assembly.

  1. Separate the steering sliding yoke from the power steering link assembly.



5. SEPARATE TIE ROD END SUB-ASSEMBLY


    C108515E02
  1. Remove the cotter pin and nut.

  1. Using SST, separate the tie rod end sub-assembly from the steering knuckle.

    SST
    09628-00011  

    NOTICE:
    1. Make sure that the string of the SST is securely tied to the vehicle.
    2. Be careful not to damage the ball joint dust cover.
    3. Be careful not to damage the steering knuckle.
    4. Be careful not to damage the front disc brake dust cover.



6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


    C132425
  1. Remove the 2 nuts and the front stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



7. REMOVE FRONT STABILIZER LINK ASSEMBLY RH


    C139012
  1. Remove the 2 nuts and the front stabilizer link assembly RH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



8. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for removal of the engine assembly (Click here for 2AZ-FE , Click here for 2GR-FE).



9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH


    C132433
  1. Remove the 2 bolts and the front No. 1 stabilizer bracket LH from the front frame assembly.



10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH


    C139011
  1. Remove the 2 bolts and the front No. 1 stabilizer bracket RH from the front frame assembly.



11. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING
  1. Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.



12. REMOVE FRONT STABILIZER BAR