REAR WHEEL ALIGNMENT > ADJUSTMENT |
| 1. INSPECT TIRES |
| 2. MEASURE VEHICLE HEIGHT |
![]() |
Bounce the vehicle up and down at the corners to stabilize the suspension. Inspect the vehicle height.
| Engine | Transaxle | Front A - B | Rear C - D |
| 2AZ-FE | Automatic | 115 mm (4.53 in.) | 38 mm (1.50 in.) |
| 2AZ-FE | Manual | 116 mm (4.57 in.) | 39 mm (1.53 in.) |
| 2GR-FE | Automatic | 117 mm (4.61 in.) | 42 mm (1.65 in.) |
| 3. INSPECT TOE-IN |
![]() |
Bounce the vehicle up and down at the corners to stabilize the suspension. Inspect the toe-in.
| Toe-in (total) | - |
| A - B: | 4 +- 2 mm (0.16 +- 0.08 in.) |
| 4. ADJUST TOE-IN |
![]() |
Measure the lengths of the right and left rear No. 2 suspension arms.
![]() |
Loosen the lock nuts.
Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
Tighten the lock nuts.
| 5. INSPECT CAMBER |
| Camber | Right-left difference |
| -1°00' +-45' (-1.00° +-0.75°) | 45' (0.75°) or less |