REAR SHOCK ABSORBER > INSTALLATION |
| 1. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING |
Install the rear shock absorber with coil spring to the rear axle carrier assembly and insert the 2 bolts from the rear of the vehicle.
![]() |
Slowly jack up the vehicle using a wooden block and install the rear shock absorber with coil spring (upper side) to the vehicle.
![]() |
Install the 3 nuts to the upper side of the rear shock absorber with coil spring.
![]() |
Install the 2 nuts and 2 bolts to the lower side of the rear shock absorber with coil spring.
![]() |
Fully tighten the lock nut.
| 2. CONNECT REAR SPEED SENSOR |
![]() |
Install the rear brake flexible hose and rear speed sensor wire harness with the 2 bolts.
| 3. INSTALL REAR STABILIZER LINK ASSEMBLY LH |
![]() |
Install the rear stabilizer link assembly LH to the rear shock absorber with the nut.
| 4. INSTALL REAR SUSPENSION SUPPORT NO. 1 COVER |
![]() |
Engage the 4 claws and install the rear suspension support No. 1 cover.
| 5. INSTALL REAR WHEEL |
| 6. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) |
![]() |
Install the rear side seatback assembly with the bolt.
| 7. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH (for Fold Down Seat Type) |
| 8. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) |
![]() |
Install the separate type rear seatback assembly with the 2 bolts.
| 9. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Fold Down Seat Type) |
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
![]() |
Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.
| 11. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (for Fold Down Seat Type) |
| 12. INSTALL REAR SEAT HEADREST ASSEMBLY (for Fold Down Seat Type) |
| 13. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Reclining Seat Type) |
![]() |
Install the separate type rear seatback assembly LH with the 2bolts and 2 nuts.
![]() |
Engage the 3 clamps and install the cover.
![]() |
Install the 2 rear seat belts.
| 14. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Reclining Seat Type) |
| 15. INSTALL REAR SEAT BACK COVER (for Reclining Seat Type) |
| 16. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
![]() |
Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.
Confirm that the seat cushion is firmly installed.
| 17. INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 18. CHECK ABS SPEED SENSOR SIGNAL |
| 19. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |