REAR SHOCK ABSORBER > REASSEMBLY |
| 1. INSTALL REAR SHOCK ABSORBER |
Install the rear No. 1 spring bumper to the piston rod.
![]() |
Install the rear coil spring lower insulator onto the rear shock absorber.
![]() |
Using SST, compress the rear coil spring.
![]() |
Install the rear coil spring to the rear shock absorber.
![]() |
Install the rear suspension support assembly.
![]() |
Align the notches of the shock absorber with the notch of the rear suspension support assembly so that the notches face the outside of the vehicle.
Install the rear shock absorber collar.
Loosely tighten a new lock nut to the rear suspension piston rod.
![]() |
Release the spring while adjusting the rear suspension support assembly to the position shown in the illustration, and remove the SST from the rear coil spring.