Home › SUSPENSION & AXLE › SUSPENSION › REAR STRUT ROD

REAR STRUT ROD > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN REAR STRUT ROD


    C132496
  1. Install the rear strut rod (rear side), bolt and nut, and temporarily tighten the bolt.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.



    C132459E01
  1. Support the rear axle carrier.



    C132476
  1. Connect the rear strut rod (inner side) with the bolt and nut.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.



2. STABILIZE SUSPENSION


    C108450E01
  1. Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.



3. FULLY TIGHTEN REAR STRUT ROD


    C132476
  1. Fully tighten the bolt.

    Torque:
    113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }



    C132475
  1. Fully tighten the bolt.

    Torque:
    113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }



4. CONNECT PARKING BRAKE NO. 3 CABLE ASSEMBLY


    C132474
  1. Install the parking brake No. 3 cable assembly with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }